Vision 2448 Manuel d'utilisateur télécharger pdf (Page 15)

Page 15

Chapter 3

Engraving Head

Assembly

Connector

Vacuum Hose Hanger

Spindle Block

Plate

Router Housing

Router Rail Plate

Dowel Pins

1. Make sure that the Engraving Head

Assembly and the electrical power to the

Controller is disconnected before you begin

any disassembly

2. Then unplug the Connector from behind

the Router Housing and rest it on the

Vacuum Hose Hanger

3. Insert the two Dowel Pins through the two

holes on the Spindle Block Plate and into

the Router Rail Plate.

The Dowel Pins will help you to keep

everything safely in place as you begin to

remove the 4 Screws holding the Engraving

Head Assembly onto the Router Rail Plate.

(Continued on Pg. 16)

Chapter 3: Engraving Head Removal Procedure

Chapter 5: Engraving Head Removal Procedure (Part 1 of 2)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Pas de commentaire

Vision 2448 Manuel d'utilisateur Page 15