Vision VISION-64 Guide de l'utilisateur télécharger pdf (Page 79)

Chapter 4 - The Vision Menus 79

Pause Point

This feature allows you to program a cutter pause anywhere in your job.

Move the cursor to the place that you would like the engraver to pause and

go to Pause point. You will see a symbol like the following: . When the

engraver gets to this point, it will stop and wait for you to press the start

button on the controller to restart it.

Note: This is useful if you need to change cutters in the middle of your job.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 186 187

Pas de commentaire

Vision VISION-64 Guide de l'utilisateur Page 79