Vision VISION-64 Guide de l'utilisateur télécharger pdf (Page 178)

178 Vision Software User's Guide

engraver at the back of your computer. Turn the system back on and see if

the mouse works. If it does, go into Vision and see if the status line now

reads “Waiting”.

Problem 4:

You send the job to the controller but the start light on the Vision Serial

Controller doesn’t turn green.

Solution:

1. Check the cable that runs from your computer to the Vision Serial

Controller. Unplug both ends and plug back in.

2. Make sure that the controller is in the proper mode. This can only be a

problem if you have been using the D1.4 program to run the Vision engraver

and have not changed it back to the standard Vision mode. You do this by

pressing the F2 key on the Vision Controller and then pressing the Set

Surface/Lift key.

3. Make sure that your engraver is hooked up to the correct serial port. A

quick way to check this is to look at the status line at the bottom left corner

of the screen. If it says “Waiting”, then unplug the cable that runs from your

computer to the Vision Serial Controller and follow the steps below:

A) If the status line changes to “Offline” than you are hooked up to

the correct port. There could possibly be a problem with the Vision Serial

Controller. Call your local sales representative or Vision Engraving

Systems.

B) If the status line stays at “Waiting” than you are not on the

correct port. Vision is probably detecting a modem or sound card in your

computer as being the engraver. Close all jobs, go to the System Menu and

then to Devices. Click on the machine type that you have under the Avail

Drivers. You will see a screen like the one below.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 186 187

Pas de commentaire

Vision VISION-64 Guide de l'utilisateur Page 178