Vision VISION-64 Guide de l'utilisateur télécharger pdf (Page 70)

70 Vision Software User's Guide

works. Unfortunately the technique differs from reflected light

(paper or your engraving) and transmitted light (your crt monitor)

and is affected by scaling. Thus can not be accurately represented

on the graphics view (F8) screen.

i) Initially on the first few lines, the image will always look like it

hasn’t worked or is too light or too dark, but wait until you get

further because of the eye trick you need a reasonable amount of

area to judge.

j) If using a nose cone, you must not adjust the depth of the cut

while it is in the middle of the photoengrave. This will cause you

to see a change in darkness.

Troubleshooting PhotoEngrave

Problem: My image is solid black.

Solution: Check that your PCX file is 256 colors or less. If

your PCX file is too high a resolution for your cutter width, reduce

the resolution or decrease the PCX file size.

Problem: The image is very clear but it is too light.

Solution: Increase the PCX file pixel resolution or use a

wider cutter.

5) PhotoEngrave PCX (dots): This file type is created in almost any

Windows graphics package. It takes a picture file and will engrave it as

groups of dots. The file extension is .PCX. Use the same guidelines as

above for this feature.

6) AutoCAD DXF file: This file type is created in the AutoCAD program.

The file extension is .DXF.

7) BMP Raster (Laser): This file type is used only for outputting to a laser

engraver. At this time, this function is not completed and does not work

properly. The file extension is .bmp.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 186 187

Pas de commentaire

Vision VISION-64 Guide de l'utilisateur Page 70