Vision VISION-64 Guide de l'utilisateur télécharger pdf (Page 85)

Chapter 4 - The Vision Menus 85

End angle: This number will determine the degree amount that the arc will

end.

Zero degrees is at 12 o'clock.

270 or -90 degrees is at 9 o'clock

90 or -270 degrees is at 3 o'clock

180 degrees is at 6 o'clock

If you have an arced line and want the line to be straight again, click on the

clear button and then click on Okay.

The page up and page down keys will move you up and down from line to

line.

Note: If you go into the autoplate feature after you have a line that is arced,

autoplate will erase the arc parameters. You will need to enter the arc

parameters after you are finished using the autoplate feature.

Easy Arc

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 186 187

Pas de commentaire

Vision VISION-64 Guide de l'utilisateur Page 85